Saturday, December 27, 2008

One Computer One LAN Card 2 IP addresses

Some time ago I visited a small company...
The setup consisted of about 40 computers connected to a switch... The internet connection was from two different ISP's
Later on the got 5 static IP's from one of the ISPs... Here comes the problem...
They setup 4 computers with static IP. Shared the last IP via a computer with 2 LAN cards... and one set of computers still used the other ISP connection...

Now there was a class conflict on the systems using the 4 static IPs... thought te could connect to the net.. the could never view other computers on the network as they had a different class of IP's...

SOLUTION:

--> Install two LAN cards on those 2 computers
-->Use the following trick

1) open the Local Area Connection status... (normally found in the task bar)


2)Click on Properties ... another dialogue opens up... here look for Internet Protocol (TCP/IP)



3)Select Internet Protocol and click Properties (yet again)



4)our existing settings are here... copy these down just in case you go wrong while doing something.
Next click on advanced and navigate to the IP settings tab






5)Click on add under IP addresses and enter the IP address you want to add... (make sure you do not enter addresses conflicting with other computers on the network).

Most probably you would enter an IP address of a different class so that different computers on the network are able to view each other. Enter the subnet mask according to the IP address (it normally appears automatically after the IP address is entered and u click on it).





6) Click Add
Click OK and close the advance Settings Dialogue
Click OK and close Internet Protocol (TCP/IP) properties
Click OK and close Local Area Connection properties

You're Done and all set to go

First Check our internet connectivity.
Next check if you are able to view other computers from the different classes...

7) NJOY....

Looks complicated but trust me its simple

No comments:

Post a Comment